I have this on both of my Arctic Cat ATV's and will definitely be installing it on my new Yamaha Wolverine X4! Works just as intended, especially while using the winch to raise and lower the snow plow so that I don't jam the hook into the rollers.
$11.00
Product Code: ATV-SCHS
Manufacturer: KFI Products
This "Split Cable Hook Stopper" is for the ATV and UTV winch. It weighs 4 oz and is 2 5/8 inches wide and 1 3/4 inches thick. This KFI Split Cable Hook Stopper will fit between the two outside rollers on an ATV or UTV winch fairlead. It also works great with the synthetic rope and or the slot fairlead.
Reasons to purchase a Split Cable Hook Stopper :
Installation:
Note: Wear leather gloves
1) Freespool winch and pull out approx 2 feet of cable
2) Remove the four bolts fastening the two halves of the Split Cable Hook Stopper together. Place the cable or rope between the two halves. Insert the four bolts and tighten until halves barely touch. Do not overtighten these bolts or you will damage the hook stopper.
3) To stow hook, engage clutch and retract cable onto winch spool until hook is snug against the hook stopper and fairlead
4) Position hook stopper at approx. 3/4 of the total line distance towards hook while using your winch
I have this on both of my Arctic Cat ATV's and will definitely be installing it on my new Yamaha Wolverine X4! Works just as intended, especially while using the winch to raise and lower the snow plow so that I don't jam the hook into the rollers.
This stopper actually serves its purpose by putting a little pressure on the cable hook, it keeps it from flopping around when the cable is in its retrieved position. The stopper fits perfectly against the roller fairlead ...definately worth the money!
